ULTRASONIC CALIBRATION BLOCKS

 

IIW V1 BLOCK

iiw-type-1-test-block-500x500Product description:

  • Used for calibration of shear and longitudinal transducers, and verification of shear wedge exit point and refracted angle.
  • Can also be used for resolution and sensitivity checking
  • Dimensions: 0 mm x 100.0 mm x 300.0 mm
  • Alloy: 1018 Steel, , ss , aluminium, stainless steel Nickel-plated

IIW V2 BLOCK

 558d161ba31f1Product description:

  • V2 Small Calibration Block For On-site Checking Of Miniature
  • Shear Wave Probe Index, Time Base, Beam Angle and Gain.
  • From 35 to 75 Degrees.
  • In Accordance With Standards.
  • Made From: 1018 Steel, Aluminium & Stainless Steel

 

DSC BLOCK

test-block-250x250

 Product description:

  • AWS-type block used for shear wave distance and sensitivity calibration.
  • Metric version
  • Fitted wooden storage case optional.

 

DC BLOCK

Scratch and Dent 059_large

 Product description:

  • AWS-type block used for shear wave distance calibration.
  • Contains a 25.0 mm radius overlaying a 50.0 mm radius on a 180° segment. 
  • In accordance with ASTM E164 and BRR/AWS X-1 specifications.

 

 IOW BLOCK

Scratch and Dent 152_large

Product description:

  • Used for beam profile measurement of angle beam transducers and measurement of transducer angles.
  • Contains nine 1.5mm diameter x 22mm deep side drilled holes.
  • In accordance with British Standard 2704 requirements.
  • Dimensions: 305mm x 75mm x 50mm
  • Made from carbon steel
  • Fitted wooden storage case optional

DS BLOCK

UT_AWS-Type_DS_Test_Block Product description:

  • AWS-type block used for longitudinal distance and sensitivity calibration.
  • Contains a 2.0″ high section between two 4.0″ sections.
  • In accordance with AWS requirements…

 

 FBH BLOCK SETS

imagesProduct description:

  • Set of nineteen flat-bottom hole blocks used to determine the relationship between metal travel distance (MTD) and signal amplitude.
  • All blocks have the same size flat-bottom hole and varying MTD.
  • Hole diameter must be specified when ordering (3/64”, 5/64” or 8/64”).
  • In accordance with ASTM E428.

DRILLED HOLE SIZING BLOCK

index

 Product description:

  • This block contains (9) 1/16″ diameter thru-holes located from 0.100″ to 0.900″ from the scanning surface.
  • Nominal location is laser engraved on the side of the block.
  • Dimensions: 1.000″ x 1.000″ x 10.000″
  • Made from 1018 Steel, Nickel plated.
  • Blocks can be made in most alloys, including exotics.

 

STEP WEDGES

hd 656066793_607 90curvedss_small 4 step

 

 

Product description:    

  • These Various Step block is the metric “A” version.
  • Variations of this block are available if additional steps are preferred.
  • Also, larger step faces are offered for use with large diameter transducers.
  • In accordance with ASTM E797.
  • Also 90° Curved Step block is machined from solid 2″ diameter bar with Various step thicknesses.
  • Materials: carbon steel, Aluminium, SS